Account

Cart

Land Rover

Powertrain

Engine

📎 Fuel Trims, P0170 | Bad O2 Sensor | Rover 45 

 

Transmission

 

4WD | AWD | Transfer Case | Differential

 

Chassis

ABS | Traction Control

 

Power Steering

 

Suspension

Suspension Level Calibration Procedure
  • Note:  You need to have +-3mm precision (use a metric ruler).
    • If it will not go through calibration due to measurements errors, computer will store C1A00-control module fault and will be there until you go through calibration successfully.
  • Make sure that there are no codes stored in Ride Leveling Module.
  • Set a hight level to a ‘normal mode’ (middle indicator ON, others OFF)
  • Start a vehicle for 5 mins to make sure that air pump will pressurize the system to the required level.
  • Enter calibration through ‘Service Functions’.
    • Once procedure has been started, it has to be completed since it clears old values from the computer’s memory.
  • Computer will try to set a vehicle to specific height. Wait for 1-2 mins for it to complete.
  • Enter measurements in mm from the center of the wheel  to a fender arc
    • 378mm < measurement < 597mm
    • Land Rover Suspension Calibration Measurements
  • After 4 measurements has been entered, car will randomly change its height for you to take a second set of measurements.
  • After this step has been passed successfully, calibration should be complete.

 

 

TPMS

 

Body

 

ECM & Immobilizer Programming

 

Speedometer

 

Airbag System 

 

HVAC

 

Radio & Navigation

Battery | Charging

 

Lighting

 

Seats

 

Power Door Locks | Tailgate | Sliding Doors | Convertible Top

 

Windows, Sunroof

 

Driver Assistance | ADAS

 

Parking Assistance

 

Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments
0
    0
    Your Cart
    Your cart is emptyReturn to Shop